Abstract
BackgroundDifferent processing techniques are employed to obtain poly (methyl methacrylate) (PMMA) with consistent surface quality in terms of topography and tribological function. The purpose of this research is to evaluate its influence on the surface height distribution.MethodsIn this research, samples of conventional and CAD/CAM acrylic resins were prepared. The following surface roughness parameters were extracted from the profilometric readings: arithmetic mean roughness (Pa), skewness (Psk) and kurtosis (Pku). Profilometric profiles were additionally obtained.ResultsThe average roughness (Pa) with the conventional technique was significantly higher compared to CAD/CAM (t = 4.595; P < 0.001). Heat-cured resins presented the highest mean Pa (F = 6.975; P = 0.06). Heat-cured and milled resins show lower coefficient variation (CV) values, indicating more consistent surface finishing. The surface profiles revealed distinct characteristics in terms of skewness and kurtosis.ConclusionsThe surface processing method, chemical composition and resin type significantly influence the surface finishing of the resin. The CAD/CAM resins exhibited superior results in terms of surface arithmetic mean roughness (Pa). However, heat-cured resin revealed to present the better surface consistency.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
