Abstract
It has been experimentally observed that mode II critical energy release rate ( G IIC) values determined by four-point end notched flexure test and three-point end notched flexure test are different for the same material. At the present work correction factors related to bending rotations are introduced to explain the differences between values of G IIC obtained by three point and four point end notched flexure tests. The bending angle leads to the contact zones between specimen and supports and specimen and load rollers changing in both test configurations. The present analysis has been carried out by the classical beam theory, neglecting shear effects and assuming the hypothesis of small rotated angles. Results show that the relative differences between corrected and uncorrected values of G IIC are greater in the case of four-point end notched flexure than in the case of three-point end notched flexure test.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
