Abstract
ABSTRACTThermoplastic starch powders and films were produced by using different combinations of hydrophilic (malic acid and water) and amphiphilic (isoleucine and butyric acid) plasticizers. Spray drying was used to produce thermoplastic starch powder followed by compression molding for the development of films. In all plasticized formulations, the rate of retrogradation was inhibited until the seventh day. The crystallinity and moisture sensitivity of the freshly prepared films were dependent on amphiphilic plasticizer quantity in formulation. Fourier transform infrared spectroscopy and thermogravimetric analysis showed an effective interaction of starch with isoleucine. Isoleucine formulated films showed the highest tensile strength, whereas malic acid-rich films showed better strain values.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call