Abstract
The structural-phase state, tribotechnical and durometric properties of hypersonic coatings made of steels 95Cr18 and 06Cr19N9T, as well as pseudo-alloys 95Cr18—AD1 and 06Cr19Ni9Ti—AD1, obtained by hypersonic metallization, have been investigated. It was found that the sprayed coatings from pseudo-alloys 95Cr18—AD1" and 06Cr19Ni9Ti—AD1 contain mainly α-Fe, which is due to alloying of steel particles in the process of spraying with aluminum. It is shown that coatings made of 95Cr18 and 06Cr19Ni9Ti steels have a higher wear resistance under dry friction conditions as compared to composite coatings. The reduced wear resistance of pseudo-alloys is associated with the presence of a large amount of relatively soft aluminum in them. It is shown that the corrosion resistance of a composite coating made of Fe—Al in a 10 % aqueous solution of NaCl is about 2 times higher than that of coatings made of high-chromium steels 95Cr18 and 06Cr19Ni9Тi.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
