Inductive Power Line Harvester With Flux Guidance for Self-Powered Sensors

Abstract

Self-powered sensors are expected to enable new large-scale deployment and location access capabilities for sensor systems. Energy harvesting devices have been shown to provide adequate power densities but their dependence on very specific environmental conditions restricts their applicability. Energy harvesting from power line infrastructure offers an architecture for addressing this challenge, because such infrastructure is widely available. In this paper an inductive power line harvester concept is presented, based on a flux concentration approach adapted to a closed-loop core geometry. Flux concentration is studied by simulation, showing a 26% flux increase using a 1:3 geometrical concentration ratio in a closed-loop core. A 20×20×25 mm prototype with a U-shaped soft-core sheet and a 200-turn Cu coil around a 5 mm diameter, 20 mm long soft-core rod is introduced. The total device volume is 9.1 cm <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">3</sup> . Characterization results on a power line evaluation setup for currents up to 35 A RMS and a 50 Hz – 1 kHz range are presented. Power between 2.2 mW (50 Hz) and 233 mW (1 kHz) is demonstrated on an ohmic load, from a 10 A RMS power line current, employing impedance matching with reactance cancellation. The corresponding power densities are 0.24 mW/cm <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">3</sup> and 25 mW/cm <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">3</sup> respectively, per total device volume. This performance is adequate for enabling self-powered wireless sensor networks installed along power distribution lines.