Abstract

We describe a chemical sensor based on a simple synthesis of zinc oxide nanorods (ZNRs) for the detection of dopamine molecules by a potentiometric approach. The polar nature of dopamine leads to a change of surface charges on the ZNR surface via metal ligand bond formation which results in a measurable electrical signal. ZNRs were grown on a gold-coated glass substrate by a low temperature aqueous chemical growth (ACG) method. Polymeric membranes incorporating β-cyclodextrin (β-CD) and potassium tetrakis (4-chlorophenyl) borate was immobilized on the ZNR surface. The fabricated electrodes were characterized by X-ray diffraction (XRD) and scanning electron microscopy (SEM) techniques. The grown ZNRs were well aligned and exhibited good crystal quality. The present sensor system displays a stable potential response for the detection of dopamine in 10−2 mol·L−1 acetic acid/sodium acetate buffer solution at pH 5.45 within a wide concentration range of 1 × 10−6 M−1 × 10−1 M, with sensitivity of 49 mV/decade. The electrode shows a good response time (less than 10 s) and excellent repeatability. This finding can contribute to routine analysis in laboratories studying the neuropharmacology of catecholamines. Moreover, the metal-ligand bonds can be further exploited to detect DA receptors, and for bio-imaging applications.

Highlights

  • Spatial and temporal analysis requirements make electrochemical sensors promising tools to investigate the role of neurotransmitters that have an electroactive nature [1,2,3,4], where the electrodes could be chemically modified for selectivity [5]

  • scanning electron microscopy (SEM) images of the polymeric membrane film on the zinc oxide nanorods (ZNRs) before and after measurements are shown in Figure 3b,c, respectively

  • We have shown that ZNRs functionalized with PVC in combination with β-CD as ionophore can be used for the detection of DA by a direct physical adsorption method

Read more

Summary

Introduction

Spatial and temporal analysis requirements make electrochemical sensors promising tools to investigate the role of neurotransmitters that have an electroactive nature [1,2,3,4], where the electrodes could be chemically modified for selectivity [5]. Since potentiometric sensors do not require external power sources and no current passes through them during detection, they are very attractive for developing sensors for biological systems. This is in addition to other advantageous features such as simplicity, cost effectiveness, and fast analysis, along with high sensitivity and selectivity [7,9]. ZnO has been extensively used for chemical and biological sensing due to its thermal stability under usual operating conditions, as well as excellent biomimetic properties combined with high electron communication features which makes it an attractive actuator for the so-called third generation biosensors [27,28,29,30,31,32,33]. It is known that the sensing mechanism of ZnO is of the surface controlled type, in which the grain sizes, surface states, and oxygen adsorption quantities all play important roles in its sensitivity [6,31,38,39,40,41,42]

The Fabrication of ZnO NRs on the Gold Coated Glass Substrate
Membrane Preparation
Results and Discussion
Conclusions
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call