Abstract
PurposeTo quantify and to compare a gravimetric and three-dimensional (3D) analysis of the removed tooth structure for different complete crown preparations. MethodsA total of 80 molar resin teeth and 8 preparation finishing lines were chosen: 1 for metal ceramic crowns (MCC); 3 for zirconia all-ceramic crowns: knife edge (ZirKnE), chamfer (ZirCha), and shoulder (ZirSho); 4 for lithium disilicate: light chamfer (LDLCha), chamfer (LDCha), shoulder (LDSho) and table top. Teeth were individually weighed to high precision and then prepared following the preparation guidelines. The teeth were reweighed after preparation, and the amount of structural reduction was calculated. In addition, all teeth were scanned before and after preparation, and the 3D volume of removed dental tissue was calculated, superimposing the two .stl files, as a difference of the volumes before and after the preparation. Kruskal–Wallis statistical analysis was carried out to determine significant differences among the groups with a significance level of p<0.05. ResultsBoth analyses showed that LDLCha, ZirKnE and table-top preparations produced the smallest amount of removed structure, whereas the preparations for MCC, ZirSho and LDSho were more destructive. For MCC, 2.6 times more tooth structure must be removed than for table top. ZirKnE was 17.82% and LDLCha was 21.51% more conservative than MCC. The data obtained through the volumetric method were similar with those obtained by gravimetric analysis. ConclusionsZirKnE, LDLCha, and table-top preparations produced the least amount of tooth tissue removal. Three-dimensional volumetric analysis can be a possible alternative to gravimetric analysis.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.