Improving the performance of vertical flow constructed wetlands by modifying the filtering media structure.

Abstract

The aim of this research was to study the influence of the bed media configuration and particle size on the treatment efficiency of subsurface vertical flow (VF) constructed wetlands (CWs) treating municipal wastewater. Two outdoor pilot units (VF1 and VF2, planted with Phragmites australis) with the configuration C1 were operated in parallel for 2 years at similar surface loading rates of 9.7 ± 3.2 (VF1) and 10.1 ± 3.3 (VF2) g biological oxygen demand (BOD5)/m2·day (19.5 ± 6.4 (VF1) and 20.4 ± 6.2 (VF2) g chemical oxygen demand (COD)/m2·day). A different configuration C2 was used during the third year at 16.9 ± 4.6 (VF1) and 18.2 ± 3.0 (VF2) g BOD5/m2·day and 26.0 ± 7.2 (VF1) and 28.0 ± 4.7 (VF2) g COD/m2·day. Two different filtering materials (1-3-mm sand for VF1 and 2-6-mm fine gravel for VF2) were used for configuration C1. The same units were modified after 2 years of operation by adding a 10-cm layer of fine sand (0-2 mm) on the top (configuration C2). In C1 conditions, the unit with the coarse material VF2 showed significantly (p < 0.05) lower removal efficiencies of total suspended solids (TSS) and BOD5 than VF1, and both units failed to meet the BOD5 discharge limit. In C2 conditions, removal efficiencies reached 82% TSS, 97% BOD5, 76-81% ammonia, and 60-66% TN, without significant differences between VF1 and VF2 units. Removal efficiencies were significantly higher for configuration C2 than that for C1, due to the positive effect of the upper fine sand layer. The presence of this fine sand layer doubled the water retention time and increased the removal rates, while the infiltration rates were high enough for an operation free of clogging.