Abstract
This study tested the mercury emission characteristics of six municipal solid waste incinerators (MSWIs) and recommended future mercury control via adjusting operational parameters. The results indicated that over 99% of the mercury in solid wastes ended in fly ash and flue gas, of which 3.3-66.3% was emitted to air through stack gas. Mercury in the stack gas was mainly in the form of oxidized mercury (Hg2+), the proportion (65.4-89.0%) of which was far higher than previous estimation (15%). Mercury removal efficiencies (MRE) of the tested incinerators were in the range of 33.6-95.2%. The impact of waste incineration capacity, gas flow, fly ash yield, and activated carbon (AC) injection on MRE were analyzed. We found that the MRE was significantly linearly correlated to the ratio of AC injection and fly ash yield (correlation coefficient = 0.98, significance <0.01). AC injection value is determined based on the control of dioxin emissions without considering mercury control in traditional design. To increase MRE of MSWIs, the AC injection should increase from around 100 mg·Nm-3 to 135 mg·Nm-3 for grate furnace combustor and 170 mg·Nm-3 for circulation fluidized bed combustor, so as to reach a MRE of 90%.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.