Improvements to the APEX apparatus

Abstract

A number of technical issues led us to rework extensively the APEX apparatus in summer 1994. During the earlier runs, a significant fraction of the 432 silicon detector elements showed degraded resolution such that they had to be excluded from the final analysis in software. The effect of this is to reduce the efficiency of APEX and possibly also to introduce holes in the acceptance which, for some perhaps exotic scenarios, might reduce the acceptance to an unacceptably low level. Also, the energy thresholds below which it is not possible to generate timing information from the silicon detectors, were high enough that the low-energy acceptance of APEX was compromised to a significant extent. The origins of these difficulties were in part due to degraded performance of the silicon detectors themselves, problems with the silicon cooling systems and electronics problems. Both silicon arrays were disassembled and sub-standard detectors replaced, all detectors were also cleaned with the result that all detectors now performed at the specified values of leakage current. The silicon cooling systems were disassembled and rebuilt with the result that many small leaks were fixed. Defective electronics channels were repaired or replaced. The rotating target wheel was also improved withmore » the installation of new bearings and a computer-controlled rotation and readout system. The rebuilt wheel can now run at speeds up to 900 rpm for weeks on end without breakdown. The target wheel and associated beam sweeping now work extremely well so that low-melting-point targets such as Pb and In can be used in quite intense beams without melting.« less