Abstract

A five-axis machining center is known for its synchronous control capability, allowing complicated three-dimensional surfaces, such as propellers and hypoid gears, to be quickly created. Prior research has shown that it is necessary to improve not only the machined shape accuracy but also the machined surface roughness of free-form surfaces. Therefore, in this research, we aimed to maintain the feed speed vector at the endmilling point by controlling two linear axes and a rotary axis with a five-axis machining center to improve the machined surface quality. In previous research, we suggested reducing the shape error of machined workpieces (referred to as shape error in this research) by considering the differences in the servo characteristics of the three axes in the machining method. The shape error was significantly decreased by applying the proposed method, which uses a parameter (referred to as precedent control coefficient in this research) determined by calculation, rather than trial and error. Moreover, to maintain the feed speed vector at the endmilling point when machining complex shapes, a rapid velocity change in each axis is required, causing inaccuracy owing to torque saturation. The results of the experiments and simulations of previous research indicated that torque saturation can be evaluated via simulation. In this research, to reduce the shape error while avoiding torque saturation when movement has high angular velocity, we developed a theoretical method to obtain the most suitable precedent control coefficient of each axis by using a block diagram that considers torque saturation. Therefore, both shape error reduction and torque saturation avoidance can be realized by using the proposed method.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call