Abstract
Determination of the generator neutral grounding system through a distribution transformer can be done through manual calculations. Many parameters are considered in the calculation to get the appropriate results there is the possibility of repeated calculations. This is very difficult and causes a large difference in the calculation results. Therefore, a computer-based computing system is needed to overcome this kind of problem. Several papers have developed the calculation of the required generator neutral earthing magnitude which considers the voltage level, short-circuit fault current and protection system against ground faults. This paper discusses modeling in designing generator neutral ground using the LabView Graphical User Interface (GUI) application. The goal is to be easier, faster and more accurate. As the implementation of the modeling used data from std C62.92.2TM-2017.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Journal of Informatics, Electrical and Electronics Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
