Abstract
Influence of different environmental factors on the degradation of film samples based on polylactic acid and low density polyethylene with the addition of aged polyethylene was studied in this work. The article presents data after 100 hours influence of UV irradiation (λ=254 nm) obtained by differential scanning calorimetry (DSC) and electronic paramagnetic resonance (EPR). It was found that polylactide is more prone to UV degradation than polyethylene. It is shown that the effect of UV radiation for 100 hours reduces the melting point of polylactide from 165 to 135 °C, while the thermal characteristics of polyethylene vary slightly. There is a decrease in the melting temperature of the polylactide by 10-30 °C in all compositions. In the compositions with the content of PLA is more than 50 wt. % correlation time after UV exposure is significantly reduced.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IOP Conference Series: Materials Science and Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
