Abstract
Introduction. Currently, there are various technologies for water treatment and water purification, including ozonation of water, water treatment with UV radiation, ion exchange, magnetization. Electrochemical treatment of water by direct electric current, in which activated water is formed, characterized by many anomalous properties, is a modern approach to water treatment and water treatment. Purpose of the study. The study of the physicochemical properties of water-activated in devices of different manufacturers with different designs. Material and methods. To activate the water, activators were used: AP-1, Melesta, Zdrava, the filter of electrochemical water purification “ Izumrud”. The activity of hydrogen ions and the redox potential of water were measured using an Ecotest-120 ionomer with a switch. To measure the electrical conductivity of the solutions, an Expert-002 conductometer was used. Free chlorine was determined by the photocolorimetric method on a Spectroquant Multy colorimeter. Antioxidant activity was determined spectrophotometrically using a mediator system of potassium ferro-ferricyanide. Results. Chloride ions make a decisive contribution to the change in the physicochemical characteristics of anolyte upon activation of water. Sulfates and bicarbonates do not affect the prooxidant activity of the anolyte. The relaxation of catholytes obtained in membrane activators proceeds by a gradual increase in ORP, while the relaxation of activated water in the Zdrava diaphragmless activator proceeds in an oscillatory mode and is characterized by sharp changes in ORP. Anolytes are stable over time and slightly change the pH and ORP during storage. The activation of certain types of water in a diaphragmless activator does not lead to a decrease in the ORP, but its significant growth. Conclusion. Electrochemically activated water is a general term that hides in each case an unknown substance with an unpredictable effect. The use of standard devices even when using the same water sample, as a rule, leads to different physicochemical characteristics of activated water. When using different types of water, physicochemical characteristics differ significantly. The use of electrochemically activated water is unsafe.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.