Abstract

In this study, we have investigated the impact of repeated shear displacement on powder flow properties. We show that when multiple yield loci are obtained using the same bulk solid specimen by stepping through different stress levels (i.e., stress walk [SW]), the shear deformation of the powder in a rotational shear cell, that is, Schulze Ring Shear Tester, is maximized, reducing the powder shear strength. This approach is material and time sparing; however, it imprecisely predicts better powder flowability. The magnitude of the change in the unconfined yield strength, σc, due to this prolonged shear displacement appears to be material-dependent, being less impactful for free-flowing powders. Using the SW and the individual yield loci-generated flow properties, we have demonstrated that in hopper design, the shear displacement effect impacts the computed critical arching diameter more than the critical mass flow angle. This knowledge of powder flow properties highlights limitations associated with the SW. An exponential function was found to describe the relationship between the change in σc at the highest major principal stress and the density weighted flowability, ffρ, with an R2 of 0.98. Such a model could be a valuable tool for correcting shear strength results obtained from SW, saving time, and material.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.