Abstract
The duty-cycle randomness (DCR) of the Bragg grating of the distributed feedback (DFB) lasers introduced by the fabrication process is inevitable, even with state-of-the-art technologies such as electron beam lithography and dry or wet etching.This work investigates the impact of grating DCR on DFB laser performance through numerical simulations. The result reveals that such randomness causes a reduction in the side mode suppression ratio (SMSR), and deteriorates the noise characteristics, i.e., broadens the linewidth and increases the relative intensity noise (RIN). With the grating DCR, the effective grating coupling coefficient decreases as evidenced by the reduced Bragg stopband width. However, the longitudinal spatial hole burning (LSHB) effect in the DFB lasers can somewhat be diminished by the grating DCR. The seriousness of these effects depends on different grating structures and their coupling strengths. Our simulation shows that a degradation of 17 dB can be brought to the SMSR of the uniform grating DFB lasers with their duty cycles taking a deviation of ±25% in a uniformly distributed random fashion. It also broadens the linewidth of the quarter-wavelength phase-shifted DFB lasers by more than 2.5 folds. The impact of this effect on the RIN is moderate—less than 2%. All the performance deteriorations can partially be attributed to the effective reduction in the grating coupling coefficient of around 20% by such a DCR.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.