Abstract
Aim The success of implant-supported restorations depends on the stability of osseointegration and the amount of bone-to-implant contact. The aim of the present study is to assess the influence of the crown-to-implant ratio on marginal bone loss in prosthetic restorations with single implant-supported crowns. Materials and methods Retrospectively, 65 patients with one missing tooth in the mandibular molar area were collected. All prosthetic restorations were made with single crowns, and all implants used were “bone level” type having a diameter in the range of 3.9 to 4.0 mm and a length of 10.0 to 13.0 mm. Cone beam computed tomography (CBCT) were performed in central occlusion. The height of restorative space was measured over the cross-sections from the level of the alveolar ridge to the corresponding antagonist crowns. Available bone height, width and length were also evaluated prior to implantation. Marginal bone loss was measured on pre-calibrated periapical radiographs, using ImageJ 1.52 (National Institutes of Health, Bethesda, Maryland, USA), in third and fifth year after the functional load. Results Positive linear correlation, statistically significant, has been determined between the crown-to-implant ratio and the amount of crestal resorption. The highest peri-implant bone loss was recorded in cases with crown-to-implant ratio of 1.5/1 and higher. Conclusion The results of this study indicate that prosthetic restorations with higher crown-to-implant ratio tend to cause higher marginal bone loss than those with lower one, in the mandibular molar area.
Paper version not known (
Free)
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call