Impact of Alfa fibers morphology on hydration kinetics and mechanical properties of cement mortars

Abstract

The Alfa plant is indigenous and spans a large zone throughout North Africa. Recently, Alfa plant has been used in building materials, notably as a reinforcement. This study aims to valorize the Alfa plant into fiber-reinforced mortar based on a cement-glass composite mix design. Two Alfa fiber morphologies are considered herein: different cutting lengths (10, 20 and 30 mm), and ground using a knife mill (shorter than 2 mm). These fibers were added to mortars at various volume ratios: 1, 2 and 3%. The workability and density of these distinct formulations were then measured in their fresh state. In comparison with the control mortar (CM), the introduction of Alfa fibers (either cut or ground), with ratios below 2% vol., leads to a slight decrease in mixture workability. However, Alfa fibers do not significantly alter the fresh material density. It was recorded a delay in setting time of the composites as a function of fiber addition rate. In the hardened state, an improvement in flexural strength is noticed for mortars reinforced with 1% vol. of fibers compared to the CM. However, results show that the increase in either type of fiber (cut or ground) generates a decrease in compressive strength compared to the CM. This outcome can be confirmed by both the decrease in heat released during the hydration reaction and water-accessible porosity inside the matrix.