Abstract
ABSTRACT Along with industrialization and transportation, the higher living standard is also the main reason for the increase in energy demand. This increasing energy demand motivates researchers to find new alternative fuels that are eco-friendly and sustainable. In this concern, to analyze the performance, emissions, and combustion characteristics of an SI engine fueled by petrol-acetylene under DF mode is the main purpose of this study. For this purpose, a VCR spark ignition engine was used and operated at the engine maximum speed (1800 rpm). The experimental study was carried out at different acetylene gas flow rates and spark timing. In this study, the acetylene gas flow rate was first optimized on a performance basis. Furthermore, the engine was run at an optimized acetylene gas flow rate (100 LPH) to find out the optimum value of spark timing. In further experimentation, it is also found that the BThE to be maximum and emissions were significantly low or comparable at spark timing 20º CA bTDC (at 100 LPH) as compared to other spark timing and baseline case at all loads. The effects of NOx and smoke are not considerable. Hence, it is not covered in this study. The heat release rate and peak cylinder pressure are found to increase with the advancement of spark timing. But knocking was observed at higher spark advance.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.