Abstract
HypothesisIce adhesion to rigid materials is reduced with low energy surfaces of high receding contact angles. However, their adhesion strength values are above the threshold value to be considered as icephobic materials. Surface deformability is a promising route to further reduce ice adhesion. ExperimentsIn this work, we prepared elastomer surfaces with a wide range of elastic moduli and hydrophobicity degree and we measured their ice adhesion strength. Moreover, we also explored the deicing performance of oil-infused elastomeric surfaces. The ice adhesion was characterized by two detachment modes: tensile and shear. FindingsThe variety of elastomeric surfaces allowed us to simultaneously analyze the ice adhesion dependence with deformability and contact angle hysteresis. We found that the impact of these properties depends on the detachment mode, being deformability more important in shear mode and hydrophobicity more relevant in tensile mode. In addition, oil infusion further reduces ice adhesion due to the interfacial slippage. From an optimal balance between deformability and hydrophobicity, we were able to identify surfaces with super-low ice adhesion.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
