Hygroscopic growth and cloud droplet activation of xanthan gum as a proxy for marine hydrogels

Abstract

AbstractKnowledge of the physical characteristics and chemical composition of marine organic aerosols is needed for the quantification of their effects on cloud microphysical processes and solar radiative transfer. Here we use xanthan gum (XG)—a bacterial biopolymer—as a proxy for marine hydrogels. Measurements were performed for pure XG particles and mixtures of XG with sodium chloride, calcium nitrate, and calcium carbonate. The aerosol hygroscopicity parameter (κ) is derived from hygroscopic growth factor measurements (κgf) at variable water activity (aw) and from cloud condensation nuclei activation efficiency (κccn). The Zdanovskii, Stokes, and Robinson (ZSR) hygroscopicity parameter derived for multicomponent systems (κmix, sol) is used to compare measurements of κgf and κccn. Pure XG shows close agreement of κgf (at aw = 0.9) and κccn of 0.09 and 0.10, respectively. Adding salts to the system results in deviations of κgf (at aw = 0.9) from κccn. The measured κgf and ZSR‐derived hygroscopicity parameter (κmix, sol) values for different solutions show close agreement at aw > 0.9, while κgf is lower in comparison to κmix, sol at aw < 0.9. The differences between predicted κmix, sol and measured κgf and κccn values are explained by the effects of hydration and presence of salt ions on the structure of the polymer networks. Results from this study imply that at supersaturations of 0.1 and 0.5%, the presence of 30% sea salt by mass can reduce the activation diameter of pure primary marine organic aerosols from 257 to 156 nm and from 87 to 53 nm, respectively.