Hydrothermal liquefaction of sewage sludge – effect of four reagents on relevant parameters related to biocrude and PFAS

Abstract

Catalytic hydrothermal liquefaction (HTL) can convert wet biomass into crude-like oil and has potential to degrade pollutants during the thermal depolymerization process. To avoid negative environmental impacts from per- and polyfluoroalkyl substances (PFAS) in sewage sludge after its final disposal, we comprehensively evaluated catalytic destruction of PFAS in sludge through HTL. The results showed that adding red mud to HTL was beneficial for the biocrude yield and significantly increased the carbon conversion efficiency and energy recovery of the hydrothermal process. HTL at 300 °C for 2 h degraded > 96% of spiked perfluorooctanoic acid (PFOA). The mass of spiked perfluorobutanesulfonic acid (PFBS) and perfluorooctanesulfonic acid (PFOS) and pre-existing perfluorohexanoic acid (PFHxA) and perfluoroheptanoic acid (PFHpA), however, increased in the HTL product streams. The remaining PFAS after HTL mainly stayed in the biocrude phase. Our findings indicated that HTL under the studied condition was not able to degrade all PFAS existed in sewage sludge. Although adding red mud could improve the HTL performance with respect to biocrude, this reagent did not improve the removal of perfluoroalkyl acids (PFAAs). As a matter of fact, the hydrothermal process amended with the selected reagents resulted in increased mass of PFBS, PFHxA, and PFHpA in the HTL products due to degradation of PFAA precursors. Thus, other treatment approaches for PFAS removal from sewage sludge need to be identified to prevent possible contamination of environments receiving PFAS-containing sludge.