Abstract
ABSTRACTThe influence of attaching hydrophobic side groups to a polyelectrolyte, used for deposition of a multilayer oxygen gas barrier thin film, was investigated. Polyethyleneimine (PEI) was labeled with pyrene and deposited in “quadlayers” of PEI, poly(acrylic acid), PEI, and sodium montmorillonite clay using layer‐by‐layer assembly. Thin films made of three repeating quadlayers using unmodified PEI had much lower density (1.24 g/cm3) than pyrene‐labeled PEI‐based films (1.45 g/cm3), which is believed to be the result of greater chain coiling from the increased hydrophobicity of pendant pyrene groups. This increased density in pyrene‐labeled PEI layers allowed three quadlayers to match the oxygen transmission rate of a four quadlayer film made with unmodified PEI. This discovery provides an additional tool for tailoring the barrier behavior of clay‐based multilayer thin films that could prove useful for a variety of packaging applications. © 2014 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2014, 52, 1153–1156
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Journal of Polymer Science Part B: Polymer Physics
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
