Hydrophobic Conductive Coatings for Fuel Cell Gas Diffusion Layers

Abstract

Mass transfer of the reactant gases, water management, thermal and electrical conductivity are all highly depending on the properties of the gas diffusion layer (GDL) in polymer electrolyte fuel cells (PEFCs). GDLs are produced in complex and energy demanding processes including high temperature graphitization and are modified using polytetrafluoroethylene (PTFE) to introduce the hydrophobicity needed to efficiently remove water [1]. PTFE is, however, negatively impacts the required electrical conductivity and is facing an uncertain future with the pending restrictions on the use of perfluoroalkyl substances (PFAS) [2], [3]. Therefore, we have investigated the use of electrically conductive polyaniline (PANI) coatings on carbon fiber substrates with modifications to increase hydrophobicity. As substrate, AvCarb carbon paper EP40 was used and PTFE treated EP40T was used as state-of-the-art reference. EP40 was coated through dip-coating or electro-coating using PANI modified with sodium dodecylbenzenesulphonate as additive to adjust hydrophobicity [4]. With this approach, we have been able to show comparable pore volumes and pore surface areas (Figure 1) through mercury porosimetry as well as comparable hydrophobic properties.