Hydrophilic modification of P(VDF- co-CTFE) porous membranes

Abstract

This paper describes fabrication of a poly(vinylidene difluoride- co-chlorotrifluoroethylene) (P(VDF- co-CTFE)) porous membrane via non-solvent induced phase inversion and subsequent hydrophilic modification using high efficient surface initiated atom transfer radical polymerization (ATRP). The effect of viscosities of casting solutions on microstructures of the P(VDF- co-CTFE) membrane was investigated. The surface chemistry, thermal stability, morphological structure, and hydrophilicity of the modified membranes were evaluated by Fourier Transform Infrared Attenuated Total Reflection (FTIR-ATR), Differential Scanning Calorimeter (DSC), Scanning Electron Microscope (SEM), and contact angle measurements, respectively. The degree of grafting and the degree of swelling were measured to analyze the effect of polymerization time on the wettability. The mechanical strength of the membranes after modification was also investigated. The permeability and fouling resistance were evaluated according to pure water flux and protein solution filtration measurements. The results demonstrate that the hydrophobic P(VDF- co-CTFE) membrane can be feasibly modified by immobilization of hydrophilic poly(ethylene glycol) methyl ether methacrylate (PEGMA) brushes via surface initiated ATRP.