Abstract
Oyster populations within the Chesapeake Bay have been drastically reduced over the last century mainly due to unregulated human activities and diseases. Regulations and restoration efforts have focused on restoring oyster populations while also considering their ability to provide ecosystem services, such as coastal protection and water quality improvement, among others. To promote oyster growth and the settlement of new populations, a recent technique adopted along the east coast of the US is the use of oyster castles (OCs). OCs have proven effective in recruiting and retaining oysters and in promoting both vertical growth and horizontal expansion of oyster habitats. OCs are widely used in coastal protection as greener alternative to common engineering solutions. We quantified hydrodynamic differences that occur around these OCs during their early stage (i.e. castles without oysters), and with fully developed oysters covering the surface of the castles through a series of laboratory experiments. The experiments were conducted in a recirculating Odell-Kovasznay type channel at the Ecohydraulics and Ecomorphodynamics Laboratory (EEL) at the University of Illinois. OCs (both with and without oysters) were 3D printed at 1:7 scale to fit the canal, and Particle Image Velocimetry (PIV) was used for 2D flow characterization. Data showed noticeable differences in flow acceleration atop the castles when covered with oysters, as well as an increase in the generation and distribution of turbulent kinetic energy atop and around the oyster-covered castles. Magnitudes and spatial distribution of Reynolds stresses were also affected by the presence of oysters in both submerged and near-emergent conditions. Challenges associated with the estimation of the drag coefficient for both gray and oyster-covered OCs highlighted the need for more data besides the centerline 2D PIV output. Further research involving the whole three-dimensional structure of the flow, in both unidirectional and oscillatory conditions, will allow us to provide relevant guidelines on the design and use of oyster-populated breakwaters as a viable nature-based solution for coastal protection within low-energy environments.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have