Hydrodynamic performance assessment of photocatalytic reactor with baffles and roughness in the flow path: A modelling approach with experimental validation

Abstract

Purification of wastewater is essential for human being as well as for the flora and fauna, and sustainable environment. Photocatalytic reactor with TiO2 coated layer can be used to degrade the pollutants but without proper pollutant mass transfer in the reactive surface, photocatalytic reactor decreases its effectiveness. The baffles and rough surface in the flow path can improve the fluid mixing to enhance pollutant mass transfer to improve the reactor's performance. In this study, a computational fluid dynamics (CFD) model has been developed to investigate the effect of four top baffles and three rough surfaces (semi-circular, triangle, and rectangle) on pressure drops, mass transfer and the hydrodynamic performance of the reactor. The experimental investigation was carried out using Formic Acid (FA) as pollutant in feed water for model validation. The simulated result varies only within 5% with the experimental data of FA concentration versus feed flow rate and fluid velocity. The model was run at fluid velocity of 0.15 m/s and 0.5 m/s (Reynolds number of 2150 (laminar flow) and 7500 (turbulent flow), respectively. The simulation result shows that the addition of baffles and roughness on the reactive surfaces increases the turbulent kinetic energy (minimum increase 8%) and consequently increases the mass transfer (maximum increase 37%) of the pollutant. The highest wall shear was observed to be 40 Pa when both square and triangular elements were used as roughness elements at turbulent flow condition. The results also shows that the highest pressure-drop of 8 kPa was found when the square roughness element was used at turbulent flow condition. Overall, the photocatalytic reactor performance is significantly enhanced by the application of combined baffles and roughness elements in the reactive surface.