Hydrodynamic design of an enclosed Horizontal BioReactor (HBR) for algae cultivation

Abstract

Modeling and optimization of key design parameters of bioreactors are critical for development of economically and technically viable algae technologies. The objective of this study is to use computational fluid dynamics (CFD) modeling to design a novel enclosed Horizontal BioReactor (HBR) equipped with a paddle wheel that incurs low capital and operating costs like raceway ponds, but achieves high productivities like enclosed photobioreactors. For the HBR the aspect ratio (length-to-width), paddle wheel diameter and positioning, culture depth, and baffle spacing can be manipulated to achieve adequate flow of the culture that minimizes the formation of low-velocity areas, below 20cm/s, termed “dead zones”. The CFD procedure focused on minimizing dead volume and power consumption. A small-scale HBR (3m2 of surface area) was used for development and validation of the hydrodynamic model, whose parameters were calculated using experimental data. The model was then applied to a pilot-scale HBR (40m2) that is operated outdoors. Placing the paddle wheel at either end of the reactor or incorporating baffles minimized the dead volume. The same effect was also achieved by increasing the size of the paddle wheel or the number of paddle wheels or the depth of the culture. On the other hand, increasing the reactor's aspect ratio resulted in more dead volume, although it decreased power consumption. These findings will be incorporated into the design of large-scale HBRs (200m2) for commercial deployment.