Human–seat interface analysis of upper and lower body weight distribution

Abstract

The human–seat interfaces were analyzed to determine the differential distribution of the body weight to the components of seat. Fifteen volunteers were tested on a simulated seat system with two piezoelectric force platforms, one placed as chair seat pan and the other placed on the floor surface as footrest. The seated configurations included back inclines (75° and 80°), upright (90°) and reclines (95°, 105° and 115°), absence or presence of armrest (adjusted at 62–68 cm of height), forward and backward sloping of the seat pan, and supported and unsupported back. The armrest and backrest assemblies were isolated from the force platforms. The difference in the body weight (kgf) to the sum of forces recorded at seat pan and feet yielded the extent of weight transferred to other features (e.g., backrest and armrest). The weight distributed at seat was 10–12% less at back inclines ( p<0.01) as compared to upright unsupported sitting. With the backrest reclined beyond 95°, the weight at seat gradually decreased by 9% at 115° recline. The load distributed at feet varied narrowly; however, it was significantly greater ( p<0.01) at upright supported back, compared to unsupported back. The height of the armrest was optimized at 68 cm, since the weight distribution at seat pan consistently reduced by 12% at that height, as compared to the absence of armrest ( F (4,524)=8.80, p<0.05). The suggested height of the armrest corresponded to 40% of the body stature of the selected volunteers. The load distributed at feet was 18% greater with the presence of armrest, indicating that a part of the weight of the upper leg fell on the seat pan, when the armrest was absent. The weight fell on the seat in slouch posture was 5% less than in upright sitting, while the weight at feet was marginally higher in slouch than in upright posture. The study maintained that the horizontal as well as 5° forward slope of the seat might be the preferred choice, since the load distributed at seat was highest at backward sloping seat for all conditions of supported and unsupported back. The study reaffirms that the backrest and armrest have conjoint influence in reducing the load distributed at seat, which in turn might help in mitigating stress on the spinal and other paraspinal structures. Relevance to Industry The human–seat interface analysis and understanding of body weight distribution to the components of seat may be beneficial for ergo-design application in optimizing parameters for chair configurations that provide comfort and safety to the user.