Abstract
Measurements on constant temperature hot wire anemometers in steady flow have been carried out to determine the dependence of the anemometer signal on the angle of yaw, the support orientation and the wire length to diameter ratio. The calibration results are subsequently applied to turbulent flow measurements. Evaluation of the first and higher order correction terms to the hot wire signal is carried out for both single and X hot wires.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
