Homogeneous methylation of wood pulp cellulose dissolved in LiOH/urea/H 2O

Abstract

Spruce sulphite cellulose (number average degree of polymerization 620) dissolved in an aqueous solution of 8% (w/w) LiOH*H 2O and 12% (w/w) urea was methylated with dimethyl sulphate (DMS). By varying the reaction temperature between 22 and 50 °C, the molar ratio between 9 and 15 mol DMS per mol anhydroglucose unit, and the reaction time from 4 to 24 h, methyl cellulose (MC) with degree of substitution (DS) values in the range of 1.07 and 1.59 was prepared. The chemical structure of MC was analysed by FTIR and 1H NMR spectroscopy. The turbidity (given in nephelometric turbidity units, NTU) of the aqueous solution of MC reached an optimum of 10 NTU for a product obtained with 12 mol DMS/mol AGU at 50 °C. GPC measurements revealed polymer degradation to a certain extent. The intrinsic viscosity and the Huggins constant k of the MC samples increased with increasing DS value. The MC samples possess k values higher than 0.8, indicating association of the polymer chain. The zero-shear viscosity decreased with increase of both temperature and the amount of methylation agent due to the depolymerization. During the heating/cooling cycle (20–90 °C) of the aqueous solutions of MC, it was observed that samples synthesized at 22 °C with DS values lower than 1.3 did not undergo phase separation in aqueous solution. Phase separation hysteresis with a precipitation temperature up to 80 °C was obtained for aqueous solutions of MC with DS values between 1.07 and 1.66 synthesized at higher temperatures. The functionalization pattern determined by GLC of the corresponding partially methylated glucitol acetates is close to randomness and comparable with those of commercial MC samples.