Abstract
This study investigates the material removal mechanisms and machining damage in drilling of carbon fiber epoxy composite by electrical discharge machining (EDM). Detailed investigation of the morphology of the machined surfaces and elemental analysis were conducted inside a scanning electron microscope. Machining damage was characterized by the extent of delamination, hole taper, and the average width of the heat-affected zone (HAZ). The effect of pulse-on time and gap current on machining damage was also investigated. It was found that material removal occurred mainly in the form of decomposition of the polymer matrix and thermally induced fracture of the carbon fibers. Vaporization of the carbon fibers due to spark and Joule heating is also a possible mechanism. The width of HAZ was found to be influenced the most by pulse-on time where the minimum HAZ occurred for intermediate pulse-on time. Furthermore, the width of HAZ and hole taper in EDM were found to be comparable to or less than those obtained by laser cutting.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
