Highly selective electrocatalytic CO2 reduction to multi-carbon products at CuPd synergistic sites over OD-Cu based catalysts

Abstract

CO2 reduction is a potential way to kill two birds with one stone by converting greenhouse gas into fuels through clean energy. Cu-based catalysts, with a wide range of products, often have limited selectivity and low activity for specific products. In this study, Cu2O was used as the oxide-derived copper (OD-Cu) substrate, which was loaded with CuPd nanoparticles by using pulsed potential and galvanic replacement. Theoretical calculations revealed that the strong H-affinity Pd sites can reduce the selectivity of formate by stabilizing *COOH and simultaneously lowering the d-band center of neighboring Cu. Additionally, the asymmetric C–C coupling of *CHO+*CO, distributed between Cu and Pd sites, can lower the free energy change of rate-determining step to promote production of the C2+ products. Faradaic efficiency (FE) of the C2+ products over Cu2O-CuPd0.5μM was more than three times higher than that over untreated Cu2O NW, rising from 16.50 % to 54.47 % under −1 V (vs RHE) bias. Moreover, the FE for formate and CO decreased respectively from 28.57 % and 19.30 % to 3.69 % and 11.82 %, accompanied by a simultaneous increase in current density by 71.49 %.