Abstract
This article presents a switched-mode transmitter architecture using a current mode class-D (CMCD) amplifier. To achieve high average efficiency for a modulated signal the envelope of the complex baseband signal is transformed into pulses such that the CMCD amplifier is operated either at its peak efficiency or completely switched off. The CMCD amplifier has been designed based on single-tone active harmonic load-pull measurements to achieve a power-added efficiency (PAE) of 61.5% with 25 W output power at 900 MHz using LDMOS FETs. Removing the losses of the demodulation filter and of the amplifier a 10% higher efficiency than in an ideal class-B amplifier can be obtained for burst-mode operation with a peak-to-average power ratio of 10 dB. © 2010 Wiley Periodicals, Inc. Int J RF and Microwave CAE, 2010.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of RF and Microwave Computer-Aided Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
