Abstract
Standard organic light emitting diodes (OLEDs) are usually bottom-emitting, i.e. they emit light through a transparent and electrically conductive substrate. Usually, indium tin oxide (ITO) is used for this purpose. However, as indium is a very expensive metal, replacing it is of vital interest for cheap OLED mass production, especially when it comes to lighting applications. We suggest the use of a polymer instead of ITO, carrying out both hole transport and injection. In contrast to conventional approaches, which use a conductive polymer on top of ITO as smoothening and hole injection layer, we employ solely a highly conductive polymer in combination with an OLED comprising doped charge transport layers. This allows us to renounce the ITO layer underneath. We use a new, highly conductive formulation of PEDOT:PSS, called Baytron® PH 500, with a conductivity of typically 500 S/cm, providing a smooth and electrically well-conductive substrate for the OLED stack. The use of such a polymeric injection layer and of a doped small-molecule OLED stack results in a low operating voltage of the devices. The charge transport layers of the OLED consist of MeO-TPD (N,N,N',N'-tetrakis(4-methoxyphenyl)-benzidine) doped with a low percentage of F4-TCNQ (2,3,5,6-tetrafluoro-7,7,8,8-tetracyano-quinodimethane) for the hole transport layer and of Bphen (4,7-diphenyl-1,10-phenanthroline) co-evaporated with Caesium for the electron transport layer. We demonstrate both fluorescent and phosphorescent monochromic OLEDs based on Baytron® PH 500 which achieve good efficiencies. The OLEDs made on Baytron® PH 500 are compared with devices made on an ITO anode. Although the polymer possesses a somewhat lower conductivity than ITO, efficient devices can be fabricated. For example, using the blue emitter Spiro-DPVBi (2,2',7,7'-tetrakis(2,2-diphenylvinyl)spiro-9,9'-bifluorene), we achieve an efficiency of up to 5.1 cd/A. As another example, we discuss green OLEDs based on the triplet emitter Ir(ppy)3 (fac tris(2-phenylpyridine) iridium) doped in a wide gap material. In this case, even a higher efficiency than on ITO is reached: 62 cd/A at a luminance of 100 cd/m2, corresponding to an increase in external quantum efficiency by 15% as compared to ITO.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.