Abstract
The present work is devoted to the short-time plasma nitriding of EN 1.4301 (AISI 304) austenitic stainless steel sheets in a pulsed glow discharge by means of a novel strip hollow cathode process for plasma thermochemical treatment (SHC-PTT) aiming at their use as bipolar plates of proton exchange membrane fuel cells (PEMFC). The fundamental trends in the change of the interfacial contact resistance (ICR) and corrosion resistance in dependence on the duration of plasma nitriding were studied. The investigations were focused on the capability of the method to reduce the ICR without deterioration of the corrosion resistance in a high-rate process. Within the range of experiments it could be shown that at a certain temperature, defined by improved or at least non-deteriorated corrosion resistance, the plasma nitriding rate is determined by the requested value of ICR. The simultaneously reduced ICR and improved corrosion resistance are explained by the formation of chromium nitrides on the substrate surfaces during the plasma nitriding. Acceptable ICR and corrosion resistance could be achieved in a continuous non-isothermal plasma nitriding process at a simulated strip rate up to 23 m h−1 with further potential to speed up the process.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.