High transconductance and current density in field effect transistors using arrays of bundled semiconducting carbon nanotubes

Abstract

We examine if the bundling of semiconducting carbon nanotubes (CNTs) can increase the transconductance and on-state current density of field effect transistors (FETs) made from arrays of aligned, polymer-wrapped CNTs. Arrays with packing density ranging from 20 to 50 bundles μm−1 are created via tangential flow interfacial self-assembly, and the transconductance and saturated on-state current density of FETs with either (i) strong ionic gel gates or (ii) weak 15 nm SiO2 back gates are measured vs the degree of bundling. Both transconductance and on-state current significantly increase as median bundle height increases from 2 to 4 nm, but only when the strongly coupled ionic gel gate is used. Such devices tested at −0.6 V drain voltage achieve transconductance as high as 50 μS per bundle and 2 mS μm−1 and on-state current as high as 1.7 mA μm−1. At low drain voltages, the off-current also increases with bundling, but on/off ratios of ∼105 are still possible if the largest (95th percentile) bundles in an array are limited to ∼5 nm in size. Radio frequency devices with strong, wraparound dielectric gates may benefit from increased device performance by using moderately bundled as opposed to individualized CNTs in arrays.