High-temperature thermal fatigue of Ni3Al-based single crystal alloy affected by wall thickness and peak temperature

Abstract

Complex thin-walled structures are commonly employed in turbine components to improve cooling efficiency. However, thin-walled blades are prone to thermal fatigue failure due to the high thermal stress induced by frequent and abrupt temperature fluctuations during duty cycles. The thermal fatigue behavior of Ni3Al-based single crystal alloy with thin-walled structure during 25 °C ↔ 1000 °C/1100 °C was investigated by combining thermal fatigue tests and finite element simulation. The thermal fatigue demonstrated a significant thickness debit effect, with thermal fatigue property dropping as peak temperature and wall thickness increased. Wall thickness had a more pronounced effect than peak temperature. Visible slip traces were found on the wall thickness surface, and their density was positively correlated with wall thickness. Further investigation revealed that thermal fatigue is primarily driven by the octahedral slip system ({111}<110>), with significant contributions from (111)[101‾] and (1‾1‾1)[101]. Simulations of thermal stress distribution and J-integral at the crack tip during crack initiation and propagation stages indicated that wall thickness influences thermal fatigue properties by affecting thermal stress concentration at the notch and crack tip. Higher peak temperatures increased thermal stress and reduced yield strength, thus diminishing thermal fatigue performance. A thermal fatigue crack propagation prediction model was constructed incorporating Paris' law and the J-integral. The model revealed an unfavorable correlation between material Cj/ nj and both peak temperature/wall thickness, indicating that both factors adversely affect thermal fatigue resistance.