Abstract
To improve the sensitivity of surface-enhanced Raman spectroscopy (SERS) detection, we propose a three-dimensional (3D) SERS chip based on an inverted pyramid micro-reflector (IPMR) that converges Raman scattering light signals to improve the signal collection efficiency. The influence of the geometric parameters of the inverted pyramid structure on the Raman signal collection efficiency was analyzed by simulation for the determination of the optimal design parameters. The inverted pyramid through-hole structure was prepared on the silicon wafer through an anisotropic wet etching process, followed by the sputtering of a gold film to form the IPMR. The 3D SERS chip was constructed by bonding the IPMR and the active substrate that assembled with silver nanoparticles. Using Rhodamine 6G molecules, the Raman intensity measured with the 3D SERS chip was threefold greater than that of the silicon-based SERS substrate under the same test conditions. These experimental results show that the 3D SERS chip can significantly improve the SERS signal intensity. Its 3D structure is convenient for integration with microfluidic devices and has great potential in biochemical detection applications.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.