Abstract

This study proposes an implementation based on a low-cost field-programmable gate array (FPGA) of a high-resolution pulse width modulation applied on a single-phase power factor correction (PFC) converter operating with 2 MHz switch frequency. The PFC was implemented using a half-bridge enhancement-mode Gallium Nitride (eGaN) field effect transistor with on-board gate drives (EPC9003 development board) and the MAX10 FPGA.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.