Abstract
We demonstrate the fabrication of self-aligned laser-reduced graphene oxide patterns with a spatial resolution/laser spot size ratio of 1/10, lower than anything reported before using laser-reduction. Laser light modifies graphene oxide (GO) by removing the oxygen-containing groups turning GO into a more graphene-like nanomaterial. Our method is based on high laser power density used for the reduction of GO that results in ablation of the GO film. This enabled us to remove the laser spot illuminated area while inducing the selective graphene oxide reduction at the periphery of the laser spot achieving resistivity of 1.6·10−5 Ω m, as low as values previously reported for other rGO. Therefore, we can exploit laser-induced reduction at high laser power density to pattern GO films with conductive dimensions that are a fraction of the laser spot size. This innovative method is scalable, inexpensive, and straightforward, allowing conductive circuits on arbitrary, flexible, and transparent substrates for applications in lightweight electronics and wearables.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.