High-efficiency absorption of low NOX concentration in metallurgical flue gas using a three dimensional printed large-flow microstructured reactor

Abstract

In the process of nitric acid dissolving precious metals, a large amount of NOx exhaust gas will be produced. This research aims at the development of a new method for the removal of low-concentration nitrogen oxides from metallurgical flue gas. In this process, a printed three-dimensional large-flow microstructure reactor and urea solution are used for the removal of NOx, which facilitates the greater efficiency of denitrification(≥94%). Urea plays an important role in the redox of NO 2 , such as NO 2 is reduced to N 2 in solution. Both the gas and the liquid phase simultaneously react in the microchannels of the microfluidic reactor. The channels allow the proper mixing of urea and NaClO 2 during the flow which efficiently removes NO x at low concentrations. The optimum condition for high denitration efficiency is outlined: the urea solution with 3%,temperature of the mixed solution is 293.15 K, gas–liquid flow mass ratio is 1:1, pH value (8.0–10.0), C NaClO2 = 0.02 mol/L. This work successfully describes the use of a microfluidic reactor to enhance and maintain the denitration efficiency. This work describes how to successfully enhance and maintain the denitration efficiency while using a printed three-dimensional large-flow microstructure reactor.