Heat transfer performance and electrohydrodynamic characteristics optimization of a dividing-wall-type ionic wind heat exchanger

Abstract

Heat exchangers play a major role in reducing emissions and conserving energy. There is a plethora of theoretical research on the enhancement of heat transfer caused by ionic wind, but there is still a lack of studies on the practical application of ionic wind in heat exchangers to increase heat exchange capacity. This work developed an original ionic wind heat exchanger with a dividing wall. It may be applied to difficult circumstances when conventional heat exchangers fail for air-to-air heat exchange. The study conducted experiments to investigate the impact of many factors, including intake air velocity, discharge spacing, and electrode distribution scheme, on the ionic wind intensity and the heat exchanger's increased heat transfer coefficient. A two-dimensional model was used to analyze the internal flow and thermal properties of the heat exchangers with wire emitters. By combining active and passive heat exchange technologies, an ionic wind heat exchanger with serrated grounded electrodes was presented. The outcomes demonstrated that a suitable intake air velocity enhances the heat exchanger's capacity for heat exchange. The improved heat exchange effect of ionic wind is more important when the inlet wind speed is less than 1 m/s. When the intake air velocity approaches 1.3 m/s, the ionic wind has less of an impact on the heat exchanger's capacity for heat exchange. The benefits of improved heat transfer are promoted by placing the emitter closer to the channel entry. Increasing the operating voltage further enhances the heat transfer enhancement ratio (HTER). The number and arrangement of wire electrodes should be chosen with consideration for the 'barrier effect' between neighboring emitters and the distance from the entrance when utilizing multiple wire electrodes. In comparison to the three-wire and five-wire electrodes, the four-wire electrode heat exchanger's HTER values were increased by 5.9 % and 14.3 %, respectively. The ionic wind heat exchanger's capacity for heat transfer is further increased using a zigzag grounding electrode. The zigzag uses a decreased aspect ratio, and the emitter is positioned slightly above the tip, improving the system's heat transfer capabilities. When compared to a heat exchanger with a flat plate grounded electrode, the four-wire electrode heat exchanger produced a 158 % increase in HTER value.