Heat transfer and microstructure during the early stages of metal solidification

Abstract

Transient heat transfer in the early stages of solidification of an alloy on a water-cooled chill and the consequent evolution of microstructure, quantified in terms of secondary dendrite arm spacing (SDAS), have been studied. Based on dip tests of the chill, instrumented with thermocouples, into Al-Si alloys, the influence of process variables such as mold surface roughness, mold material, metal superheat, alloy composition, and lubricant on heat transfer and cast structure has been determined. The heat flux between the solidifying metal and substrate, computed from measurements of transient temperature in the chill by the inverse heat-transfer technique, ranged from low values of 0.3 to 0.4 MW/m2 to peak values of 0.95 to 2.0 MW/m2. A onedimensional, implicit, finite-difference model was applied to compute heat-transfer coefficients, which ranged from 0.45 to 4.0 kW/m2 °C, and local cooling rates of 10 °C/s to 100 °C/s near the chill surface, as well as growth of the solidifying shell. Near the chill surface, the SDAS varied from 12 to 22 (µm while at 20 mm from the chill, values of up to 80/smm were measured. Although the SDAS depended on the cooling rate and local solidification time, it was also found to be a direct function of the heat-transfer coefficient at distances very near to the casting/chill interface. A three-stage empirical heat-flux model based on the thermophysical properties of the mold and casting has been proposed for the simulation of the mold/casting boundary condition during solidification. The applicability of the various models proposed in the literature relating the SDAS to heat-transfer parameters has been evaluated and the extension of these models to continuous casting processes pursued.