Abstract
Turbulent fully developed flow heat transfer coefficient and friction factor of Al2O3 nanoparticles are dispersed in water and ethylene glycol in circular tube is discussed in this paper. In order to validate the heat transfer coefficient and friction factor of nanofluid in circular tube commercially available CFD software FLUENT 6.0 is used. To achieve the fully developed flow condition, the aspect ratio (L/D) of the test section is equal to 94. The thermo-physical properties of the Al2O3 nanofluid are estimated by using the equations available in literature. Thermo-physical properties of the nanofluid are considered for heat transfer coefficient and friction factor by assuming nanofluid is a single-phase fluid. Constant Wall Heat Flux (CWHF) boundary condition is incorporated for heat transfer analysis and adiabatic boundary condition is incorporated for friction factor analysis. The analysis is conducted in the volume concentration range from 0.1% to 4%. A maximum of 2.25 times heat transfer enhancement and 1.42 times of friction is obtained by using nanofluid as working medium.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.