Heat Flux Estimation of a Flame Thermal Spray Process Using a Thermally Thin Composite Calorimeter

Abstract

Temperature measurements take on prime importance in the field of the thermal spray coating since the temperature variation greatly affects the formation of splat morphology and also the coating properties and qualities. The evaluation of the heat flux is therefore essential since temperature variation comes from the energy transfer and conduction of the thermal system. The aim of this study is to estimate the heat flux of a flame thermal spray by solving an inverse heat conduction problem. Firstly, the substrate material and geometry are well designed so that the Biot number is small enough to conform to the lumped capacitance conditions. A lumped capacitance model of a substrate with its coating subjected to a uniform echelon heat flux is evaluated by solving a heat balance equation in the Laplace domain. Then, a thermally thin calorimeter is designed and the experimental thermogram is obtained by embedding a thin-wire micro-thermocouple onto the front and rear faces of the substrate. The forced convective heat transfer coefficient as well as the net incident heat flux density brought to the substrate during the thermal spray process are estimated. The theoretical composite surface temperature is compared to the experimental recording, the result showing a good agreement.