Abstract
Martensitic stainless steels are suitable for diverse structural applications but degrade when subjected to wear-prone activities in service. To enhance their service life, the densification of high Cr, martensitic, X190CrVMo20-4-1 tool steel powder on two different martensitic stainless steel substrates via supersolidus liquid-phase sinter (SLPS) cladding was investigated. The objective was to assess the influence of the difference in compositions of the martensitic stainless steels employed as substrates on the interfacial diffusion, microstructure, hardness and bonding strength of the steel-to-steel claddings. Computational thermodynamics and diffusion simulations were employed to supplement experimental findings. Owing to interdiffusion, a M7C3 carbide-free, banded region exists in the X190 adjacent to the interface with the width dictated by chemical potential gradient of carbon. The hardness of the substrate was lower near the interface region because of carbon enrichment, which promoted the presence of retained austenite. An interfacial strength of 798 MPa was achieved with fairly ductile X190 matrix near the cladding interface as the fracture surface was characterized by mixed fracture modes of dimple rupture and cleavage with localized quasi-cleavage features. Experimental observations and computational simulations are in agreement. The implications of the SLPS cladding technique are discussed in the context of tool development.
Highlights
THE combination of high strength and resistance to corrosion made martensitic stainless steels one of the choice materials for the development of structural components and parts of machinery for the food, chemical, mineral processing, oil and gas industries.[1,2,3,4] the degradation of these materials when subjected to wear- and corrosion-prone activities in service is inevitable
Since there was no liquid phase fraction expected in the substrates, the bonding between the sintered X190CrVMo20-4-1 tool steel powder (X190) steel powder and the substrates is expected to be dominated by elemental diffusion
The effect of the difference in the composition of the substrates on the interfacial diffusion bonding, microstructure, hardness and bonding strength was evaluated with the following key conclusions drawn: (1) The microstructure of the densified X190 steel powder at a temperature of 1280 °C for 30 minutes is characterized by the dispersion of fine
Summary
THE combination of high strength and resistance to corrosion made martensitic stainless steels one of the choice materials for the development of structural components and parts of machinery for the food, chemical, mineral processing, oil and gas industries.[1,2,3,4] the degradation of these materials when subjected to wear- and corrosion-prone activities in service is inevitable. This necessitates the development of repair/remanufacturing processing routes.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.