Grain size effect on deformation twinning and detwinning

Abstract

This article systematically overviews the grain size effect on deformation twinning and detwinning in face-centered cubic (fcc) metals. With decreasing grain size, coarse-grained fcc metals become more difficult to deform by twinning, whereas nanocrystalline (nc) fcc metals first become easier to deform by twinning and then become more difficult, exhibiting an optimum grain size for twinning. The transition in twinning behavior from coarse-grained to nc fcc metals is caused by the change in deformation mechanisms. An analytical model based on observed deformation physics in nc metals, i.e., grain boundary emission of dislocations, provides an explanation of the observed optimum grain size for twinning in nc fcc metals. The detwinning process is caused by the interaction between dislocations and twin boundaries. Under a certain deformation condition, there exists a grain size range where the twinning process dominates over the detwinning process to produce the highest density of twins.