Abstract
Sn-Ag-Cu electronic solder joints typically solidify from a single nucleation event producing either a single βSn grain or twinned grains. With so few and variable βSn orientations, each joint is mechanically unique due to the anisotropy of tetragonal βSn. Here we explore the potential of increasing the number of βSn orientations in solder joints by promoting heterogeneous nucleation during solidification. It is shown that large (60 g) samples can be grain refined effectively by combining growth restricting solute with potent heterogeneous nucleant particles introduced by alloying additions of Zn, Ti, Co, Ir, Pd, or Pt. These mechanisms are discussed with reference to the grain refinement of structural casting alloys. In 500 μm solder balls, these grain refinement approaches were less effective and a relatively high cooling rate of 17 K/s combined with solute and nucleant particles were required to trigger multiple nucleation events. With this approach, up to 12 independent grains formed in 500 μm balls of Sn-3Ag-0.5Cu alloyed with Pt, Co, or Ti, compared with one independent grain in balls without nucleant particle additions.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
