Graft polymerization of methyl acrylate onto granular starch: Comparison of the Fe2/H2O2 and ceric initiating systems

Abstract

Graft polymerizations of methyl acrylate (MA) onto granular cornstarch were carried out in water with both ferrous ammonium sulfate/hydrogen peroxide (FAS/H2O2) and ceric ammonium nitrate (CAN) initiation. Starch concentrations were 10, 20, and 30% in water, and the amount of MA used was either 0.5, 1, or 2 mol per AGU of starch. Two concentrations of FAS/H2O2 were used: 1 mol each of FAS and H2O2 per 100 AGU of starch, and 1 mol per 1000 AGU. Significant amounts of acetone-extractable PMA homopolymer were produced, and homopolymer formation was especially high at the 1:100 ratio. Sharp exotherms were observed, and reaction mixtures reached maximum temperature within 2 min or less. Total conversions of MA to PMA were higher at the 1:100 ratio, and conversions in some polymerizations were nearly quantitative. CAN-initiated polymerizations were run under the same conditions used for FAS/H2O2; however, the amount of CAN used was limited to 1 mol per 100 AGU because of low conversions at the 1:1000 ratio. Compared with FAS/H2O2, CAN gave more moderate exotherms; and longer time periods were required for reaction mixtures to reach maximum temperature. CAN gave quantitative conversions of MA to PMA, but only low percentages of PMA homopolymer were observed. Differences between FAS/H2O2 and CAN initiation are consistent with differences in the two initiation mechanisms. High levels of homopolymer produced on starch granule surface with FAS/H2O2 could be seen in scanning electron micrographs and were also apparent in infrared spectra obtained with an attenuated total reflectance (ATR) cell. ATR spectra of acetone-extracted products indicated that the amount of PMA actually grafted to starch granule surfaces was similar with both initiating systems. Tensile properties of extruded ribbons prepared from these polymers did not vary greatly with the initiator used. © 1996 John Wiley & Sons, Inc.1 This article is a U.S. Government work and, as such, is in the public domain in the United States of America.